sine wave roof roll forming machine

sine wave roof roll forming machine sine wave roof roll forming machine, adjustable as customers requirment, we offer different requirments roll forming machines. This metal roll forming machine: 1. LMS Roll Forming is designed one

 sine wave roof roll forming machine

 
sine wave roof roll forming machine, adjustable as customers requirment, we offer different requirments roll forming machines.
 
This metal roll forming machine:
1. LMS Roll Forming is designed one profile for one machine, width-adjustadble for various specification.
2 Hole-Punching solution is available, customized according to clients' requirement.
3. Production process: decoiling - (hole-punching) -  roll forming  - hydraulic cutting-off - PLC controlling
4. Customized drawing or sample quotation is welcome!
sine wave roof roll forming machine, adjustable as customers requirment, we offer different requirments roll forming machines.
Main Parameters:
      Raw material: cold-rolled sheet and galvanized sheet strip in coil.
     Thickness of raw material: 2mm
      Width of the profile: 100mm
      Height of Profile: 60mm.
      Width of incoming material: 250mm
      The shape and size of profile: U-groove 60*100*60*2mm
 
The complete rollforming line comprised by following unit:
A, Decoiler
    Apply manual expansion device
    Max.outter diameter: 1800mm
    Inner diameter of coil: 500--780 mm
    Max. coil width: 300mm.
    Loading capacity: 1.5 tons
   With brake system
    Quantity: 1 set.
 
B, Main Machine
      Rollers: 12 groups, 5 straightening rollers
      Material of rollers: GCr15 steelSlip ring brush holder
      Hardness of rollers after heat treatment: 55°~57°
     The appearances of the rollers have been polished.
      Diameter of roller’s shaft: 50mm, material: 45# steel.
      Wall thickness:25mm
      Main bearing. 60309
      Main motor power 7.5KW, 350 Reducer.
      Forming speed: 12m.
 
C, Cut Off Device
    Apply hydraulic automatically cut-off device.
    Motor power 4KW.
    Equip with one set of cut-off mould  ( with waste cut-off mode)
   Cut-off mould material: Gr12 steel.
    Hardness after heat treatment: HRC58 °– 60°
 Roll forming machine
D, Run Out Table
    Apply 8# steel welding.
    Length: 6m.
   With one sample stacker
 Roll former
E, Control System
  Adopted normal control system by knob
   Electrical components adopted SILIN or joint venture products.
   Length control by limit switch or defending plate mode.   Stop to cut
   Power supply: 380V/50HZ